Summary of debugging problems of plane mask machine

Summary of the main problems of the plane mask machine:

1. Loose wires when installing the nose bridge wire

2. Clogged nose line

3. Wrinkles appear on the bridge of the nose

4. The gantry of the mask cloth feeding is uneven

5. Mask wrinkles

6. After the mask is pressed, the pressure wheel passes and the mask is deformed

7. Mask piece cannot be completely cut off

8. The final pressure wheel adjustment of the main body machine

9. Abnormal feed of ear belt machine-feed rail width adjustment

10. Abnormal feeding of ear belt machine-sensor adjustment

11, ear strap hanging line problem-push the jaws not in place

12. Adjust the far point position of the ear wire machine chain

13. Track width and ultrasonic rigid mold position adjustment

14. Indenter position adjustment

15. Ear wire welding quality adjustment

16, ear line rack rotation zero position adjustment

17. Adjusting the clamp opening position of the ear clamp jaw

18. Position adjustment of ear wire scissors

19. Abnormal feed track of ear belt machine-width adjustment of feed track

20. The feeding track of the ear belt machine is abnormal-the feeding sensor is adjusted

21. Ear strap hanging line problem-push the gripper not in place

22. Ear strap hanging line problem-insufficient welding time

23, ear strap hanging line problem-ear line clamp position is high

24. The ear wire is cut continuously-the ear wire is not on the turntable

25. The ear wire is cut continuously-the ear wire is not clamped by the jaws

26, ear line shears constantly-scissors edge adjustment

27. Poor welding of ear straps-insufficient cylinder pressure

28. How to wear cloth

29. Mask wave wheel adjustment

30. Installation and adjustment of mask folding mechanism

31. Adjustment of nose bridge wire feeding and cutting mechanism

32, mask width adjustment

33, the main body embossing shear wheel adjustment

34, cheap adjustment of the main machine center

35. The gantry of the mask cloth feeding is uneven

36. The mask sticks after the welding roller

Leave a Reply